Connecting the Serial Port

The serial port is a standard RS-232C, 25-pin port, with selectable baud rates of up to 38.4 Kbps. It requires a shielded RS-232C cable which is UL and CSA approved and no more than 50 feet (15 m) in length.

1.Open the port access cover and plug the interface cable into the serial port.

2. Secure the cable with the screws and close the port access cover.

3.Attach the other end of the cable to the computer and secure it with the screws.

Default menu settings for the serial interface (see Section 1 of your on-line Pacemark 4410 User’s Guide for information on changing Menu settings):

Parity = None

Baud Rate = 9600 BPS

# Serial Bits = 8 Bits

DSR Signal = Valid

Protocol = Ready/Busy

DTR Signal = Ready on Power Up

Diagnostic Test = No

Busy Time = 200 mS

Busy Line = SSD-

 

Pacemark 4410 Setup Guide

E-17