Left Tractor (viewed from the back of the printer)

1.Open the tractor cover, place the paper holes over the pins and close the cover.

2.Fine tune the position of the right tractor to center the paper holes on the pins of both tractors, then push the right lock lever back.

Finish Up

1.Make sure that the feed stack of paper is directly aligned (left-right) with its entry point into the tractors: this will promote a smooth flow of paper into the printer.

2.Close the rear-feed access cover and the back access door.

3. Press FF/LOAD to load the paper into the print path.

The printer is set to a default rear-feed paper width of 13.6 inches (136 columns). If you are using 9-inch paper, you must enter the printer menu and change the setting to 8 inches (80 columns) to avoid printing on the platen and

Pacemark 4410 Setup Guide

E-29