Rear Feed Continuous Forms

Paper Specifications: Rear Feed

Maximum thickness: 0.014 inch (0.36 mm)

Type

Weight

Width

 

 

 

 

Single Part

12 to 24 lb. (45 to 90 g/m2)

3* to 16.5 inches (76 to 419 mm)

Carbonless

9 to 11 lb. (34 to 41 g/m2)

3* to 16.5 inches (76 to 419

mm)

(1 + 5 max.)

 

 

 

Interleaf

9 to 14 lb. (34 to 52.5 g/m2)

3* to 16.5 inches (76 to 419

mm)

(1 + 3 max)

9 lb. (34 g/m2) carbon

 

 

 

 

 

 

*For paper widths less than 4 inches (102 mm), remove the support between the tractors.

When using paper which is thicker than 7-part carbonless or its equivalent, you must enter the Menu mode, then go to the Impact Mode item in the Set-Upgroup and select High Impact Copy as the setting.

To load rear-feed paper:

Preparation

1.Position the printer at the rear edge of the support (this promotes the unrestricted flow of paper into the printer), then place a stack of continuous forms below the printer. Recommended height of printer support, 29.5 inches (750 mm).

E-26

Pacemark 4410 Setup Guide