Load Paper

Front Feed Continuous Forms

Paper Specifications: Front Feed

Maximum thickness: 0.031 inches (0.79 mm)

Type

Weight

Width

 

 

 

 

Single Part

12 to 24 lb. (45 to 90 g/m2)

3* to 16.5 inches (76 to 419 mm)

Carbonless

9 to 11 lb. (34 to 41 g/m2)

3* to 16.5 inches (76 to 419

mm)

(1 + 9 max.)

 

 

 

Interleaf

9 to 14 lb. (34 to 52.5 g/m2)

3* to 16.5 inches (76 to 419

mm)

(1 + 6 max)

9 lb. (34 g/m2) carbon

 

 

Labels

0.011 inch (0.28 mm) thick

3¼ to 15 inches (83 to 381 mm)

Envelopes

24 lb. (90 g/m2) max.

3 to 10 inches (76 to 254 mm)

Card Stock

100 lb. (375 g/m2) max.

3 to 8 inches (76 to 203 mm)

 

 

 

 

 

*For paper widths less than 5 inches (127 mm), remove the support between the tractors.

When using paper which is thicker than 7-part carbonless or its equivalent, you must enter the Menu mode, then go to the Impact Mode item in the Set-Upgroup and select High Impact Copy as the setting.

To load front-feed continuous forms:

Preparation

1.Position the printer at the front edge of the support (this promotes the unrestricted flow of paper into the printer), then place a stack of continuous forms below the printer. Recommended height of printer support, 29.5 inches (750 mm).

Pacemark 4410 Setup Guide

E-21