
2. Advance check of the Case
Advance check before use
This Case has been the subject of thorough quality control for the parts during the manufacturing process and thorough function inspections during the assembly. In addition, a water pressure test is performed with a water pressure tester for all products to confirm that the performance conforms to the specifications.
However, depending on the carrying and storage conditions, the maintenance status, etc., the waterproof function may be damaged.
Before using, always perform the following advance checks.
Check the waterproof parts of the Case
Check the waterproof parts of the Case as described below.
1Ensure that the Case’s
2Ensure that the separately available Waterproof Port is installed correctly, and that the Waterproof Port is attached firmly to the
3Ensure that the
Advance check
1Before loading the digital camera in the Case, immerse the empty Case to confirm that there is no water leakage. When it is difficult, water leakage can be checked by referring “Water Leakage Test” (P.19).
2Main causes of water leakage are as follows.
•Forgetting to install the
•Part of an
•
•Sand, fibers, hair or other foreign matter sticking to the
•Damage to an
•Attached strap or silica gel getting caught when closing the Case.
Perform the test after the above causes have been eliminated. | En |
|
CAUTION:
If the advance test should show water leakage with normal handling, stop using the Case and contact your dealer or an Olympus service station.
EN 10