When using the TTL cable

When connecting the optional electronic flash with the underwater TTL cable (optional: PTCB-E01),

connect the hot shoe cable (optional: PHCB-01) to the camera and front cover of the Case.

Connecting the underwater TTL cable

1Turn the TTL connector cap of the Case counter-

clockwise and remove it.

2 Connect the underwater TTL cable (optional: PTCB-E01) to the TTL connector on the Case.

Insert into the connector.

Underwater

TTL cable

Use this mark to align the position.

3When not using the underwater TTL cable, attach the TTL connector cap.

Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable connector. After that, gently turn it clockwise until it stops.

Turn the threaded section of the connector clockwise gently until it stops.

Check O-rings

CapConnector

CAUTION:

If the TTL connector cap is loose, water leakage may result.

How to connect the hot shoe cable

En

1Turn the hot shoe cable connector cap inside the Case counter-clockwise to remove it.

2Insert the connector of the hot shoe cable into the Case's connector and turn the connector screws all the way clockwise to connect them firmly.

3Load the camera in the Case, and then connect the hot shoe cable to the camera.

EN 12