Manuals / Brands / Cell Phone / Carrying Case / Olympus / Cell Phone / Carrying Case

Olympus E06 3. How to connect the electronic flash, Connecting the underwater optical fiber cable

1 30

Download 30 pages, 2.25 Mb

3. How to connect the electronic flash

Connecting the underwater optical fiber cable

To connect the UFL-2 underwater flash (optional) to the Case using an underwater optical fiber cable (optional), follow the procedures below.

How to connect the underwater optical fiber cable

1 Remove the cap of the optical fiber cable insertion slot.

2Put the underwater optical fiber cable plug all the way into the optical fiber cable insertion slot.

Setting of the digital camera

1Set the RC mode of the camera to ON so that the camera's built-in flash is activated.

2Load the camera in the Case with the camera's built-in flash popped up.

Refer to the UFL-2 instruction manual for the UFL-2 operation.

				CAUTION:
				CAUTION:
		When using a non-Olympus manufacturer's slave-type flash with underwater optical fiber cable, set the
En		camera's built-in flash to manual.
En		If the camera's built-in flash ratio is more than 1/64, the camera's built-in flash light may reflect in the lens port
		and be taken into the picture.

EN 11

Contents

En Instruction Manual Introduction Please read the following items before use For safe use Page Page Contents Page 1. Preparations Check the contents of the package Page Install the Waterproof Port Attach the hand strap How to attach and detach the camera table 2. Advance check of the Case Advance check before use 3. How to connect the electronic flash Connecting the underwater optical fiber cable When using the TTL cable Page 4. Installing the digital camera Check the digital camera Open the Case Attach the digital camera to the camera table Insert the digital camera in the Case Check the loading status Seal the Case Check the operation of the loaded camera Perform the final checks Water Leakage Test 5. Handling After Shooting Wipe off any waterdrop Unload the digital camera Wash the Case with pure water Dry the Case 6. Maintaining the Waterproof Function Remove the O-ring Remove any sand, dirt, etc Install the O-ring How to Apply Grease to the O-ring Replace consumable products Maintenance of the threaded sections on the TTL cable and TTL cable connector Maintenance of the TTL Connector Cap 7. Appendix Specifications