Olympus MAUSB-100 manual Troubleshooting, Windows, Problem, Cause, Solutions

Troubleshooting

Windows

	PROBLEM	CAUSE	SOLUTIONS	REF. PAGE
	The green status lamp does not	The MAUSB-100 is not connected	Make sure that the MAUSB-100 is
	light.	correctly to the computer's USB	facing the right way and connect it	11, 22
		port.	to the computer's USB port firmly.
1		The power supply from the USB	If you are using a USB hub, it may
		port is insufficient.	not function properly with the
			MAUSB-100. Connect the	5
			MAUSB-100 directly to the
			computer.
	If you are using Windows 98/98	You have connected the MAUSB-	Click [Cancel] to close the
	SE:	100 before installing the device	window, then disconnect the
2	A [Add New Hardware Wizard]	driver.	MAUSB-100 from the PC and	9
	window appears when you		install the device driver.
	connect the MAUSB-100.
	If you are using Windows 98/98	The Universal Serial Bus	Change the [OLYMPUS MAUSB-
	SE:	Controller is Disabled.	100 xD USB Reader/Writer]
	The MAUSB-100 doesn’t work		settings or the [MAUSB-100
	even after installing the device		Enumerator] settings on the
	driver and connecting the		[Universal Serial Bus Controller]
	MAUSB-100 to the computer.		by selecting [Start] - [Settings] -	—
			[Control Panel] - [System] -
3			[Device manager]. ([X] appears.
			Right-click on [Properties] and
			clear the check box for [Disable in
			this hardware profile] on [Gen-
			eral].)
		The USB port is disabled in the	Set the USB port to “Enable” in the
		BIOS settings.	BIOS settings, referring to your	—
			computer’s instruction manual.
	If you are using Windows 98/98	The MAUSB-100 driver was not	Delete [? MAUSB-100], then
	SE:	installed correctly.	disconnect the MAUSB-100 and
	[?] appears in Device Manager.	(It is not necessary to install the	install the device driver again.
4	(This is after you have performed	device driver on Windows Me/		7
	all the steps in the [Add New	2000/XP.)
	Hardware Wizard] window for
	connecting the MAUSB-100.)
	The [Removable Disk] icon	The MAUSB-100's USB connec-	Fully insert the USB connector.
	does not appear after installa-	tor or the USB extenstion cable is		11
	tion and connection.	not connected properly to the
	[!] or [?] appears in Device	computer.
	Manager.	The Universal Serial Bus	Change the Controller settings on
		Controller is Disabled.	[Universal Serial Bus Controllers]
		(Only for WindowsMe/2000/XP)	by selecting [Start] - [Setting]
		(If you are using Windows 98/98	(only for WindowsMe/2000) -
5		SE, refer to Column 3.)	[Control Panel] - [System] -	—
			[Hardware] - [Device Manager].
			([X] appears on the controller’s
			name. Select [Enable] by right-
			clicking from the pop-up menu.)
		The USB port is disabled in the	Set the USB port to “Enable” in the
		BIOS settings.	BIOS settings, referring to your	—
			computer’s instruction manual.
	The MAUSB-100 does not	The card is not inserted correctly.	Make sure that the card is
	recognize the card.		inserted correctly.
6	[Please insert a disk into drive			10, 21
	L:.]* appears.
	*When the Removable Disk is recognized as
	the L drive.

42