Olympus MAUSB-100 manual Windows 98/98 SE, How to install, Turn on the computer, 98/98 SE Install

Windows 98/98 SE

How to install

Also refer to your computer’s user manual and the manuals for any optional devices you are using.

1 Turn on the computer <98/98 SEInstall>

Turn on your computer’s power (and connected devices) to start Windows 98/98 SE.

2 Install the device driver/utility software <98/98 SEInstall>

When using the MAUSB-100 for the first time, you must first install the device driver and utility software included on the provided CD-ROM.

Note

Do NOT connect the MAUSB-100 to the computer until installation of the device driver/ utility software is completed.

Do not connect to the computer before installation.

Before installation, make sure that the computer is turned on, then follow the steps below to install the device driver and utility software on your computer.

●Note that the windows shown below may look different on your computer, depending on how your operating system is configured.

1.Turn on the computer, then place the provided CD-ROM into the computer’s CD-ROM drive.

2.When the CD-ROM is recognized, the InstallShield setup window is displayed for a few seconds. Then, the installation window appears automatically.

3.Click the [Next] button.

●If the window at right does not appear, refer to

“If the installation window does not appear when the CD-ROM is loaded” ( p. 9).

●If you want to cancel the installation, click [Cancel].

7