44
ACTION TYPE SUBMENU:
The error that results from the measurement of the Process Variable may be
positive or negative since it may be greater or smaller than the Setpoint. If a
positive error should cause the instrument output to increase (i.e. cooling), it
would be called Direct Acting. If a negative error should cause the output to
decrease (i.e. heating), it would be called Reverse Acting.
Press d6) Display flashes DRçT Direct or RVRS Reverse.
Press b7) Scroll through the available selections: “Direct” or “Reverse”.
Press d8) Display shows STRD stored message momentarily and then
advances to AUTo only, if it was changed, otherwise press ato
advance to AUTo Auto PID Submenu (If PID Control type was
selected).
If ON/OFF was selected in the Control Type, the display skips to
the Dead Band Submenu.
AUTO PID SUBMENU:
Press d9) Display flashes ENBL Enable or DSBL Disable.
Press b10) Scroll through the available selections: “Enable” or “Disable”.
If "Enabled", the PID parameter of Output 1 will be copied to
Output 2.
Press d11) Display shows STRD stored message momentarily and then
advances to the next submenu only, if it was changed, otherwise
press ato advance to the next submenu.
If AUTO PID was ENABLED", the display skips to the CYCL
CYCLE TIME submenu. If "AUTO PID" was "DISABLED", the
display will show PRoP PROPORTIONAL BAND Submenu
allowing the user to manually enter the Proportional Band value.
The Reset and Rate value are the same as Output 1.
PROPORTIONAL BAND SUBMENU:
Press d12) Display flashes 1st digit of the previous Proportional Band
value.
Press b& c13) Press band cbuttons to enter a new Proportional Band
value.
Press d14) Display shows STRD stored message momentarily and then
advances to CYCL only, if it was changed, otherwise press ato
advance to the CYCL Cycle Time Submenu.
Refer to “Proportional Band” Submenu of “Output 1” Menu.