30
ANALOG OUTPUT ENABLE/DISABLE SUBMENU:
Press b5) Scroll though the available selection until ENBL displays to
use Analog Output Retransmission (output proportional to the
input signal).
Press d6) Display shows STRD stored message momentarily and then
advances to CURR or VoLT Submenu only if it was changed,
otherwise press ato advance to CURR or VoLT
Current/Voltage Submenu.
If DSBL Analog Output Disabled was selected, all submenus of Analog
Output Menu will be skipped and the meter will advance to ALR2 Alarm 2
Menu. If ENBL Analog Output Enabled was selected, Output 1 would be
automatically Disabled, and reassigned as Analog Output.
CURRENT/VOLTAGE SUBMENU:
Press d7) Display flashes CURR Current or VoLT Voltage.
Press b8) Scroll through the available selection: Current or Voltage
(Example VoLT ).
Press d9) Display shows STRD stored message momentarily and then
advances to RD1 Submenu only if it was changed, otherwise
press ato advance to RD1 Reading 1 Submenu.
READING 1:
Press d10) Display flashes 1st digit of previous “Reading 1” value.
Press b& c11) Enter “Reading 1” value. (Example 0000)
Press d12) Display advances to OUT.1 Out 1 Submenu.
OUT 1:
Press d13) Display flashes 1st digit of previous “Out 1” value.
Press b& c14) Enter “Out 1” value. (Example 00.00)
Press d15) Display advances to RD!2 Reading 2 Submenu.
READING 2:
Press d16) Display flashes 1st digit of previous “Reading 2” value.
Press b& c17) Enter “Reading 2” value. (Example 9999)
Press d18) Display advances to OUT.2 Out 2 Submenu.
OUT 2:
Press d19) Display flashes 1sttdigit of previous “Out 2” value.
Press b& c20) Enter “Out 2” value. (Example 10.00)
Press d21) Display advances to the ALR2 Alarm 2 Menu.
The above example is for 0-10 V of the entire range of the Process Input
and Analog Output. For 0-20 mAoutput you need to set “Analog Type” to
Current and OUT 2 to 20.00.