1.Refer to Figure 5-1 and Figure D. Snap open the Stator (1) by pushing the spring-loaded area of the Latch (2). Remove any old tubing from the pump, if necessary.
2.Refer to Figure 5-2 and Figure D. Loop the Tubing (10) over the rollers. This is easy to do even for stacked pumps.
NOTE
Tubing can be changed on stacked pumps without detaching either of the pumps from the motor.
3.Refer to Figure 5-3. Push the stator closed until you hear the latch engage.
4.Refer to Figure 5-4. Tighten the Clamp Screw (4) until the Clamp Plate (3) contacts the tubing, securing it in place.
Parts of the Pump
| 4 |
| (Clamp Screw) |
1 | 3 |
(Stator) | (Clamp Plate) |
|
2 | 10 |
(Latch) | (Tubing) |
Figure D
