Omega Vehicle Security FPU500 manual Troubleshooting Guide, Problem Solution

7

Troubleshooting Guide

Problem		Solution
No flow out of the outlet tubing	1.	Check to see that the Stator is
		snapped shut. If it is, push down on
		the Stator while the motor is
		running. This action enhances the
		self-priming capability of the pump.
	2.	Make sure the tubing is loaded
		properly. The tubing should be
		centered in the middle of the
		rollers. Reload if necessary.
	3.	Check to see that the tubing has no
		holes or cracks. Replace with new
		tubing, if necessary.
	4.	Check that the inlet tubing is fully
		immersed in fluid.
	5.	Check that the motor is rotating in
		the correct direction. Refer to Figure
		5-5.
	6.	Check to see if the tubing is
		clogged. Replace with new tubing,
		if necessary.
	7.	Check to see if the pump is properly
		mounted to the motor. Refer to
		Section 3 for instructions on proper
		mounting.
	8.	Check to see if the Rotor Assembly
		is worn or stuck. Check that the
		rollers spin freely. Use a high
		pressure air hose to blow out
		particles from the pump which may
		be restricting roller motion.

☞

7-1