ASSEMBLY AND INSTALLATION PROCEDURE
1.Install the two mounting channels on the enclosure housing using the four
2.If the wiring is to be routed through the housing, make sure that the mounting channels are oriented properly before drilling, so the Display will be readable. Wiring is generally brought into the right side of the housing or rear panel, closest to the terminals of the input module. Drill the proper size hole in the housing or rear panel for the wiring connector or sealed conduit fitting and attach the fitting(s)
3.Before installing the Display into the housing, be sure that the mounting channels are oriented properly for the type of installation planned. Place the gasket that is supplied with the Display over the studs extending from the front panel of the display.
4.If using the shroud, refer to the Shroud Installation Procedure. Place the Display with gasket through the holes in the housing as shown at right. Working back and forth across the stud pattern, install the
5.Mount the housing, using the strut nuts and steel
6.Connect the wires to the Display per the instructions included with the personality board.
7.Remove the center section of the rear panel gasket. Apply the
gasket to the rear panel of the enclosure by inserting the | * Supplied with LDP63100. |
|
screws through the panel and into the holes in the gasket. |
|
|
|
| |
Position the panel on the housing, start all of the screws, then |
|
|
firmly tighten them in a pattern working back and forth across the rear panel. | Figure 4 | |
DIMENSIONS FOR THE LDP63100 DISPLAY SHROUD
DIMENSIONS In inches (mm)
The optional LDP63100 Display Shroud enhances the readability of the Displays that are installed in areas with high intensity overhead light sources. The Shroud can be used with the LDP63100 Display in any installation, (panel mount, NEMA 4/IP65 Enclosure, or Universal Mounting Bracket). When properly assembled, the Shroud will not affect the integrity of a NEMA 4/IP65 installation. The Shroud weighs 1.0 pound (0.45 Kg).
Figure 5
SHROUD INSTALLATION PROCEDURE
Installing The Shroud On An LDP63100 Display In A NEMA 4/IP65 Enclosure Or Panel
1.Place a gasket over the studs extending from the rear of the front panel of the Display.
2.Orient the shroud as shown in Figure 6, and place it over the display. The studs of the display should now be protruding through the rear of the shroud.
3.Place the other gasket over the studs.
4.Install the unit into the panel or enclosure using the
nuts that are supplied with the Display. Tighten the nuts firmly.
Nema 4/IP65 Shroud Installation * Supplied with LDP63100.
Figure 6
9
