
REMOTE CONTROL PROGRAMMING
(English)
ATTENTION!
Must set WALL DETECT RIGHT first. Failure to do this may result in poor performance of Wall
Mount. If set LEFT WALL DETECT, please use the SETUP / RESET to clear memory
SETUP:
Push / Collapse the Wall Mount Flat against the Wall, Press and Hold for 5 seconds to set the home position (note: this also clears all memorized commands)
RESET: Hold for 5 seconds to clear all commands and memorize HOME position.
|
|
| TILT UP | |
STEP 2 |
| |||
|
|
| ||
WALL DETECT LEFT |
|
|
| |
Swivel to the closest to the |
|
|
| |
Wall without the TV |
|
|
| |
touching the Wall, leave |
|
|
| |
about 1” (25mm) of space |
|
|
| |
recommended, Hold down |
|
|
| |
|
| |||
Wall Detect for 5 seconds |
|
|
| |
till LED LIGHT color turns |
|
|
| |
solid |
|
|
| |
|
|
|
|
|
LEFT SWIVEL |
|
|
|
|
LED LIGHT
Flashing LED: Transmitting Signal
Solid Color LED: Memory Set or Cancelled
STEP 1
WALL DETECT RIGHT Swivel to the closest to the Wall without the TV touching the Wall, leave about 1” (25mm) of space recommended, Hold down Wall Detect for 5 seconds till LED LIGHT color turns solid
RIGHT SWIVEL
MEMORY 1:
Hold for 5 Seconds until LED LIGHT color turns sold, memory is set Move to another desired location and repeat above step to memorize again.
TILT DOWN
MEMORY 2:
Hold for 5 Seconds until LED LIGHT color turns sold, memory is set Move to another desired location and repeat above step to memorize again.
HOME
8
This will bring the wall mount back to the wall of HOME position that user setup, if user needs to set a different Home position, please refer to SETUP button above for details.
ATTENTION!
Power Loss or interruption DOES NOT delete or clear the memory. User
must use the SETUP / RESET button to clear memory.
If Swivel too far RIGHT or LEFT and hits / makes contact with the wall, the
unit will Stop after 2 seconds.
P35