Management Options | iConverter, Serial Agent |
Network Management
1:Chassis and Module Management
2:Set Module Identifier
Management Module Preferences
3:IP and Control Preferences
4:SNMP Preferences
5:Abandon Preference Changes
6:Save Preference Changes
7:Restore to Factory Defaults
8:Restart Management Module
9:Other Networking Features
Management Module Maintenance
10:Firmware Update
11:Set Date/Time
IP Address | = 192.168.1.220 |
| |
Chassis Number = 1 |
| ||
Enter Choice, (H)elp, E(x)it > 9 |
| ||
|
| ||
|
| ||
Other Networking Features Screen | iConverter, Serial Agent | ||
1: | Enable/Disable DHCP Client | Disabled | |
2: | Enable/Disable Keep Alive Trap | Disabled | |
3: | Keep Alive Trap interval | 10 | |
4: | Enable/Disable SW1 Switch Block | Enabled | |
5: | Serial Baud Rate | 57600 bps | |
6: | Enable/Disable VLAN Support | Disabled | |
7: | VLAN ID | 2 | |
8: | VLAN Priority | 7 | |
Enter Choice, Management Options Screen(0), (H)elp, E(x)it >
To enable DHCP client, select 1 at the Other Networking Features screen and follow the screen prompts to enable DHCP.
To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.
3.4.1.3Setting the Chassis Number and Name
A Chassis Name, or sysName, can be assigned for identification of the 10/100M in the SNMP client. The name can be any
The Chassis Number can remain as 1 (factory default) when the 10/100M is installed without an iConverter NMM in the same chassis. When the 10/100M is installed in the same chassis as an NMM, then the 10/100M must be set to the Chassis Number of the NMM.
To set the Chassis Number, select 4 at the IP and Control Preferences screen, press <ENTER> and follow the instructions to enter the chassis number.
To set the Chassis Name, select 5 at the IP and Control Preferences screen, press <ENTER> and follow the instructions to enter the chassis name.
Page 14
