4.3.3SFP Information
The 10/100M module installed with an SFP will provide general and specific information on the SFP. This information is best viewed with SNMP management software. The following is the information available:
4.3.3.1SFP A0 Information Display
This section displays fixed SFP Module information for the following areas.
• | Identifier Values | • | Extended Identifier |
• | Connector Values | • | Transceiver Codes |
• | Encoding Rules | • | Normal Bit Rate |
• | Link Length | • | Vendor Name |
• | Vendor OUI | • | Vendor Revision Number |
• | Laser Wavelength | • | Options |
• | Vendor Serial Number | • | Date Code |
• | Diagnostic Monitoring Type | • | Enhanced Options |
•
4.3.3.2SFP A2 Information Display
This section displays decoded SFP data collected for the following statistics.
• | Measured Temperature | • | Measured Vcc |
• | Measured Bias | • | Measured Tx Power |
• | Measured Rx Power | • | Temperature High Alarm Setting |
• | Temperature Low Alarm Setting | • | Temperature High Warning Setting |
• | Temperature Low Warning Setting | • | Vcc High Alarm Setting |
• | Vcc Low Alarm Setting | • | Vcc High Warning Setting |
• | Vcc Low Warning Setting | • | Bias High Alarm Setting |
• | Bias Low Alarm Setting | • | Bias High Warning Setting |
• | Bias Low Warning Setting | • | Tx Power High Alarm Setting |
• | Tx Power Low Alarm Setting | • | Tx Power High Warning Setting |
• | Tx Power Low Warning Setting | • | Rx Power High Alarm Setting |
• | Rx Power Low Alarm Setting | • | Rx Power High Warning Setting |
•Rx Power Low Warning Setting
Page 30
