![](/images/new-backgrounds/1193389/19338965x1.webp)
•Multiplexer State - Indicates the Multiplexer state (“Discard”, “Forward” or “Unknown”) of the remote ports. If “Forward” is displayed, the remote partner is forwarding
•Parser Action - Indicates the Parser Action state (“Discard”, “Forward” or “Loopback”) of the remote ports. If “Forward” is displayed, the remote partner is forwarding
•Critical Event - Indicates the Critical Event state (“Yes” or “No”) of the remote partner. If “Yes” is displayed, the local device has detected a Critical Event. If “No”, the local device has not detected a critical event.
•Link Fault - Indicates the remote partner has detected a fault in the receive direction (“Yes” or “No”). If “Yes” is displayed, the receive link is down. If “No”, the receive link is up.
•OAM Mode - Indicates the OAM mode (“Active” or “Passive”) of the remote partner.
•Supports - Indicates the supported options (Variable Access “Var”, Link Event Notification “Event”, Loopback “LB” or blank if no options are supported) of the remote partner.
•OUI - Indicates the three hex byte IEEE organizational specific identifier (or blank if unknown) of the remote partner.
802.3ah parameters can be accessed by selecting options 7 from the Port configuration screen. The fiber configuration screen is displayed.
802.3ah Control - iConverter 10/100M | iConverter, Serial Agent | |||
Identifier - |
|
|
|
|
Chassis Number = 1 | Slot Number = 1 | Model Number = | Port # = 1 | |
1: 802.3ah OAM State |
| Enabled | Local Status |
|
2: OAM Mode |
| Active | Discovery State | Incomplete |
3: Loopback Mode |
| Disabled | Multiplexer State | Forward |
4: Loopback Timeout |
| 30 sec | Parser Action | Forward |
5: Unidirectional Mode | Not Available |
| ||
|
|
| Remote Status |
|
|
|
| Discovery State | Incomplete |
|
|
| Critical Event | No |
|
|
| Link Fault | No |
|
|
| Multiplexer State | Unknown |
|
|
| Parser Action | Unknown |
|
|
| Mode | Unknown |
|
|
| Supports | Unknown |
|
|
| OUI: | Unknown |
Enter, Previous Screen (0), (n)ext page, (H)elp, E(x)it >
To configure the 802.3ah parameters for the UTP port, type an n and press <ENTER>.
Page 33