Omnitron Systems Technology 10/100M user manual Setting the Snmp Trap IP Host Addresses

authNoPriv provides authentication based on the HMAC-MD5 algorithm and authPriv provides DES 56-bit encryption based on the HMAC-MD5 algorithm.

To set User 1 security, select 10 at the SNMP Preferences screen, press <ENTER> and then follow the screen prompts. To set the User 2 security, select 13 at the SNMP Preferences screen, press <ENTER> and then follow the screen prompts.

To set User 1 privacy password, select 11 at the SNMP Preferences screen, press <ENTER> and then follow the screen prompts. To set the User 2 privacy password, select 14 at the SNMP Preferences screen, press <ENTER> and then follow the screen prompts.

To set User 1 authentication password, select 12 at the SNMP Preferences screen, press <ENTER> and then follow the screen prompts. To set the User 2 authentication password, select 15 at the SNMP Preferences screen, press <ENTER> and then follow the screen prompts.

To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.

Community name and User name can be any 1-32 character alphanumeric string Authentication Password and Privacy Password can be any 1-16 character alphanumeric string.

3.4.2.3Setting the SNMP Trap IP Host Addresses

SNMP traps are used to report events that occur during the operation of a network, and may require the attention of the network administrator. The 10/100M is capable of sending SNMP traps to up to eight different SNMP Traphosts.

To enter the IP address of the first Traphost Address, select 4 at the Management Options screen to access the SNMP Preferences screen. Select 16 at the SNMP Preferences screen and press <ENTER>. Then backspace over the existing value, type the new value (in x.x.x.x format), and press <ENTER>. To enter the IP addresses of additional trap-receiving Traphost Addresses, repeat this process for Traphost Addresses 2-8 (menu options 17-23).

To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.

3.4.2.4Enabling/Disabling SNMPv1/v2c Agent

To disable/enable SNMPv1/v2c agent, select 4 at the Management Options screen to access the SNMP Preferences screen. Select option 6 to disable/enable SNMPv1/v2c agent. When disabled, the module will not respond to any requests via the SNMPv1/v2c protocol.

3.4.2.5Enabling/Disabling SNMPv3 Agent

To disable/enable SNMPv3 agent, select 4 at the Management Options screen to access the SNMP Preferences screen. Select option 7 to disable/enable SNMPv3 agent. When disabled, the module will not respond to any requests via the SNMPv3 protocol.

Note: Both SNMPv1/v2c and SNMPv3 agents can be enabled at the same time.

Page 18