3.4.1.2Setting IP Parameters as DHCP Client
To configure the IP automatically as a DHCP client, select 9 from the Management Options screen. The Other Networking Features screen will appear.
PI
SA
Management Options | iConverter, Serial Agent | ||||
Network Management |
| ||||
1: Chassis and Module Management |
| ||||
2: | Set Module Identifier |
| |||
Management Module Preferences |
| ||||
3: IP and Control Preferences |
| ||||
4: | SNMP Preferences |
| |||
5: | Abandon Preference Changes |
| |||
6: | Save Preference Changes |
| |||
7: Restore to Factory Defaults |
| ||||
8: | Restart Management Module |
| |||
9: | Other Networking Features |
| |||
Management Module Maintenance |
| ||||
10: Firmware Update |
| ||||
11: Set Date/Time |
| ||||
IP Address | = 192.168.1.220 |
| |||
Chassis Number = 1 |
| ||||
Enter Choice, (H)elp, E(x)it > 9 |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
PI |
| SA |
|
|
|
|
| ||||
Other Networking Features Screen | iConverter, Serial Agent | ||||
1: | Enable/Disable DHCP Client | Disabled | |||
2: | Enable/Disable Keep Alive Trap | Disabled | |||
3: | Keep Alive Trap interval | 10 | |||
4: | Enable/Disable SW1 Switch Block | Enabled | |||
5: | Serial Baud Rate | 57600 bps |
Enter Choice, Management Options Screen(0), (H)elp, E(x)it >
To enable DHCP client, select 1 at the Other Networking Features screen and follow the screen prompts to enable DHCP.
To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.
3.4.1.3Setting the Chassis Number and Name
A Chassis Name, or sysName, can be assigned for identification of the GX/TM2 in the SNMP client. The name can be any
The Chassis Number can remain as 1 (factory default) when the GX/TM2 is installed without an iConverter NMM in the same chassis. When the GX/TM2 is installed in the same chassis as an NMM, then the GX/TM2 must be set to the Chassis Number of the NMM.
To set the Chassis Number, select 4 at the IP and Control Preferences screen, press <ENTER> and follow the instructions to enter the chassis number.
To set the Chassis Name, select 5 at the IP and Control Preferences screen, press <ENTER> and follow the instructions to enter the chassis name.
Page 14