Fujitsu BX400 S1 manual Contains power management settings

		Installation and operation
Power	Contains power management settings
	Power settings (1) (Default values are highlighted):
	– Consumption mode (No Consumption Control / Enforced
		Max. Limit / Low Noise Operation / Minimum Power Cons. /
		Scheduled Cons. Mode)
	–	PSU control enabled
	– PSU redundancy (No Redundancy / PSU Redundancy /
		Phase Redundancy)
	– PSU Dynamic Mode enable (ON / OFF)
	Power settings (2):
	– Maximum Power Limit (value of "Minimum Power Limit" as
		printed in the same menu)
	Power settings (3):
	–	PSU/Phase Assignment (Unassigned)
	– Phase Limit (no value)
PIN	Contains a four-digit PIN as password protection for the
	ServerView Local Service Display for Blade
	Default values:
	–	PIN enabled (OFF)
	–	PIN (0000)
Check	Ekeying Check: This is a function which allows you to query the
	compatibility of the modules before startup, and then activate,
	partially activate or deactivate the module depending on the
	result. For example, you would not activate modules whose
	operating voltages or power consumption are not compatible with
	the system.
	This test begins automatically after switch-on or after a hardware
	replacement. If errors are found, you can find out more about
	them via the Details button. Replace the defective hardware
	component and repeat the test.
Save	Clicking the Save button saves and applies the settings in the
	management blade.

With the Previous button you can go back and change parameters. You save the changed configuration with the Save button.

BX400 S1 Operating Manual 71