Fujitsu BX400 S1 manual Hot-plug components Installing a server blade

Hot-plug components

Installing a server blade

VCAUTION!

●Make sure you observe the safety notes and the information on handling electrostatic-sensitive devices in the section "Modules with Electrostatic-Sensitive Devices" on page 32.

●Beware of the energy hazard at the midplane contacts. A short circuit on these contacts may damage the system.

●The server blade boots automatically after installation in the system unit.

When you install a server blade in an active system unit, the server blade automatically performs a Power-On Self-Test (POST) and then switches itself off.

If the system unit is switched off when you install the server blade, the automatic POST is performed immediately after you switch on the system unit.

●Any unused server blade slots must be fitted with dummy modules to comply with electromagnetic compatibility (EMC) regulations and to ensure sufficient cooling of the system components.

BX400 S1 Operating Manual 83