Installation and operation

5.2Switching the system unit on/off

VCAUTION!

If you switch on the system unit and the connected monitor only shows flickering stripes, switch it off immediately (see chapter "Troubleshooting and tips" on page 77).

The On/Off button does not disconnect the device from the mains. To fully disconnect it from the mains, you must unplug the plugs from the sockets.

Turn the system unit on when the temperature is in its operating environment range (10–35°C). For details on the operating environment, refer to "Safety Precautions". When operating the device outside of this operating environment, the server may operate improperly, damage data etc. Furthermore, Fujitsu cannot be held responsible for any related damage,malfunction, or loss of data, etc.

Be sure to wait for 10 seconds or more after shutdown before turning the system unit on.

Before switching the system unit on using the On/Off button, the PRIMERGY BX400 S1 system unit must be connected to the power supply for at least a minute.

Switching on the system unit

ÊPress the On/Off button on the system unit (position 4 in figure 14 on page 57) for 2 seconds. Depending on the BIOS setting, the individual server blades will also be switched on. This is done in sequence according to the numbering of the server blade slots (see figure 20 on page 82.)

ÊIf necessary, switch on the required server blades

The system unit is switched on and the activated server blades perform a system test and boot the operating system.

Switching off the system unit

The system unit is up and running (server blades are also switched on).

ÊTo properly shut down all server blades, press the On/Off button on the front of the system unit (position 4 in figure 14 on page 57) for 4 seconds. All server blades will then be shut down.

66

Operating Manual

BX400 S1

Page 66
Image 66
Fujitsu BX400 S1 manual Switching the system unit on/off, Switching on the system unit, Switching off the system unit