Omron ZS-MDC Error Messages and Countermeasures, When Error Is Displayed on the Main Display

Section 5

Error Messages and Countermeasures

Error Messages and Countermeasures

■When [Error] Is Displayed on the Main Display

	Display Details		Cause	Countermeasure
LCD screen		Overcurrent	One or all of the judgment out-	Cancel the load short-circuit.
(upper section)			puts are short-circuited.	(Recovery is automatic after the
				load short-circuit is canceled.)
		Calculation data error	One (or all) of the channels	Check the measurement state of
			assigned to the operation input	the channels assigned to the oper-
			cannot be measured.	ation input, and set all channels to
				a measurable state.

■When all digits on the main display and sub-display blink

	Display Details		Cause	Countermeasure
LCD screen		SYSTEM ERROR	The controller is not connected.	Connect the Controller.	Section5
		BANK DATA	ler in error	onds, and then hold the DOWN
		CONNECT
		SYSTEM ERROR	Bank data in the Sensor Control-	Hold the UP key down for 3 sec-
				key down for 3 seconds.
		SYSTEM ERROR	Internal error		APPENDIX
				Turn the sensor ON again.
				The sensor is turned ON again
				and restored after the device is
				initialized.
		MAIN COM

■ Others

	Display Details		Cause	Countermeasure
LCD upper sec-		Disp range error	The measurement result	Change the decimal point digit
tion			exceeds the number of dis-	setting.
			played digits.
Main Display		– – – – – –	• The sensor is standing by	• When hold is set, start sam-
			for measurement.	pling and apply the hold
			• No channels are assigned	value.
			to inputs. (Assignments	• Assign the channels.
			are set to “NONE”.)

ZS-MDC

User’s Manual

5-3