Omron ZS-MDC user manual About Setup, Basic Knowledge for Operation, Switching Modes

Section 3 SETUP

Section 3

About Setup

About Setup

The ZS-MDC Series can be set up on the Multi-Controller or on the SmartMonitor Zero software utility.

This manual describes setup on the Multi-Controller.

For details on how to set up the ZS-L Series on SmartMonitor Zero, refer to Help contained on the SmartMonitor Zero CD-ROM.

Basic Knowledge for Operation

The following describes basic operation of the Multi-Controller before you set up the ZS-L Series.

■Switching Modes

The ZS-MDC has the following 3 operating modes.Switch to the desired mode before you start operation.

To switch the operating mode, use the Mode Switch.

TEACH

FUN RUN

Mode	Description
FUN Mode	Mode for setting the measurement conditions
RUN mode	Normal operating mode
TEACH Mode	This mode is for setting the judgment threshold values.

When you switch the operating mode after changing the measurement conditions, you will be prompted to save the settings. Save the settings as required. If you turn off the Multi-Controller with- out saving these settings, the newly set measurement conditions will be cleared from memory. You can also save all the settings later on.

Sensor Controller User’s Manual, Section 3 Setup

3-4

ZS-MDC

User’s Manual