DV-CP706 work OK but, Troller don’t?, Functions don’t

Troubleshooting—Continued

There are no batteries in the remote controller.

Install new batteries (page 17).

The batteries are ﬂat.

Replace with new batteries (page 17).

The batteries are installed incorrectly.

Check the batteries and correct as necessary

(page 17).

You’re not pointing the remote controller at

Point the remote controller at the DV-CP706’s

Buttons on the

the DV-CP706’s remote sensor.

remote sensor (page 17).

Use the remote controller closer to the DV-CP706

DV-CP706 work OK but

You’re too far away from the DV-CP706.

(page 17). The remote controller has a range of

those on the remote con-

troller don’t?

approximately 16 ft. (5 meters).

A strong light source is interfering with the

Make sure that the DV-CP706 is not subjected to

direct sunshine or inverter-type ﬂuorescent lights.

DV-CP706’s remote sensor.

Relocate if necessary.

If the DV-CP706 is installed in a cabinet with

Open the doors, or use a cabinet without colored

colored glass doors, the remote controller may

glass.

not work reliably when the doors are closed.

The

cable is not connected properly.

Make sure the

cable is connected properly.

The

functions don’t

To use

, you must make an

connection

The DV-CP706 is not connected with an ana-

and an analog audio connection (RCA) between

work?

log audio connection.

the DV-CP706 and the AV receiver, even if they are

connected digitally.

The HDMI Control setting is set to Off.

Set the HDMI Control setting to On.

A component in your system does not support

Refer to the component’s instruction manual to see

CEC.

if it supports CEC.

A component in your system has HDMI CEC

Refer to the component’s instruction manual and

control turned off.

turn on HDMI CEC control.

One of the components in your system does

Refer to the other component’s instruction manual

to see if it supports CEC and check your connec-

RIHD doesn’t work?

not support CEC or is not connected correctly.

tions.

There’s a problem with the HDMI cable that

Try another HDMI cable.

you’re using.

The DV-CP706’s settings may be changed by

disconnecting and connecting the HDMI

Display a video manually on the TV.

cable.

cable is connected to the DV-CP706.

Disconnect the