Troubleshooting—Continued

Abnormal Behavior

The DV-SP1000/DV-SP1000E contains a microprocessor for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Alternatively, press and hold the Stop [] button until “Reset” appears on the display (about 10 seconds).

Restoring the Default Settings

To reset the DV-SP1000/DV-SP1000E to its factory defaults, turn it on and, while holding down the Stop [ ] button, press the [STANDBY/ON] button. “Initialize” appears on the display. When the reset is complete, “Complete” is displayed, and the DV-SP1000/DV-SP1000E enters Standby mode.

95

Page 95
Image 95
Onkyo DV-SP1000 instruction manual Abnormal Behavior, Restoring the Default Settings