Using the remote controller

■Using the RC-448C remote controller

Installing the remote controller batteries

1Push the battery cover in the direction of the arrows shown and remove it.

Using the remote controller

When operating the remote controller, point it toward the remote control sensor of the DX-R700.

Remote control

DX-R700 sensor

30°

30°

5m

2Install the supplied (or AA, R06, or UM-3-sized) batteries into the battery compartment being careful not to mistake the polarity (follow the polarity diagram inside).

3Replace the battery cover.

Notes:

•Do not mix new batteries with old batteries or different kinds of batteries.

•To avoid corrosion, remove the batteries if the remote controller will not be used for a long time.

•Immediately remove dead batteries to avoid damage to the remote controller from corrosion. If the remote controller begins to operate improperly, remove the old batteries and replace them with two new batteries.

•The life of the supplied batteries is approx. 1 year, though this value may vary depending on usage.

Notes:

•If the remote control sensor is subjected to direct sunlight or inverted fluorescent light, operation of the remote controller may be adversely affected.

•Use of another remote controller nearby or using the remote controller near equipment that uses infrared light may cause operational interference.

•Do not put objects on the remote controller. A button on the remote controller may remain pressed and drain the batteries.

•Make sure the DX-R700 is not placed behind colored glass doors. Placing the DX-R700 behind such doors may prevent proper operation of the remote controller.

•If there is an obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

11