Onkyo DX-R700 Troubleshooting guide, Messages during recording (continued), Messages during playback, name input, and other situations

Troubleshooting guideMessages during recording (continued)

Display Cause Remedy

Pro Disc	A CD-R or a CD-RW not for music recording use
	(without the “FOR CONSUMER” marking)
	or a CD-RW has been inserted.

Eject the disc and check whether it meets the specifications for use with the DX-R700. Always insert a disc that has the markings “FOR CONSUMER” or “FOR MUSIC USE ONLY” on its surface

(see page 12).

Check Input	Synchronous recording cannot be
	performed because the detected input
	signal is from a source other than the CD,
	MD, DAT, or DCC.

Record from a recordable source.

Cannot Rec	Recording cannot be performed because
	a finalized CD-R is used.

Replace it with a non-finalized CD-R.

Recording cannot be performed because a finalized CD-RW is used.

Replace it with a non-finalized CD-RW. Or, retry recording after unfinalizing it.

Messages during playback, name input, and other situations

Display Cause Remedy

Blank Disc	You have tried to play a disc that has
	no recordings on it.

If the inserted disc is a CD-R or CD-RW with no recordings, you may record onto it, but it cannot be played.

No Disc	No disc has been inserted.	Open the disc tray and make sure that a
		disc is inserted.
Name Disc	Finalizing a disc without disc name was	Enter a disc name before attempting finalization
	attempted.	(see pages 28, 33).

Name Full	Entering name information exceeding the
	limitation of 1000 characters per disc was
	attempted.

You can enter up to 1000 characters per disc (see page 28).

Full	Entering a name exceeding the limitation of	You can enter up to 100 characters per name
	100 characters per name was attempted.	(see page 28).
Erase Name	Name input cannot be performed because	Erase the name information retained in the unit. Or,
	the unit retains name information for	write the retained name information to the previous
	a previous disc.	disc and then enter name information to the new disc
		(see pages 28, 32).
A.Finalize	Name input cannot be performed during	Cancel auto finalization before performing name input
	auto finalization.	(see pages 19, 23, 28).
Memory Full	Programming more than 25 tracks was	You can program up to 25 tracks.
	attempted.

Cannot Edit Editing a finalized CD-RW was attempted.

Unfinalize the CD-RW before attempting disc edit (see page 36). This message also appears during random playback, memory playback, or other situations where disc editing is not possible or when an ineditable disc is used.

44