Onkyo HT-R758 En-27, Listening to AM/FM Radio, Using the Tuner, Tuning into Radio Stations

Listening to AM/FM Radio

This section describes the procedure of using the buttons on the front panel, unless otherwise specified.

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

You can also change the frequency steps (➔ page 51).

1 Press AM or FM to select either “AM” or “FM”.

In this example, FM has been selected.

Band Frequency

(Actual display depends on the country.)

Tuning into Radio Stations

■ Auto tuning mode

1 Press TUNING MODE so that the AUTO indicator lights on the AV receiver’s display.

2 Press TUNING q/w.

Searching stops when a station is found.

When tuned into a station, the TUNED indicator lights. When tuned into a stereo FM station, the FM STEREO indicator lights as shown.

TUNED

AUTO

FM STEREO

Tip

•Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to manual tuning mode and listen to the station in mono.

En-27

Turning On & Basic Operations

■Manual tuning mode

In manual tuning mode, FM stations will be in mono.

1	Press TUNING MODE so that the AUTO indicator
	goes off on the AV receiver’s display.
2	Press and hold TUNING q/w.
	The frequency stops changing when you release the
	button.

Press the buttons repeatedly to change the frequency one step at a time.

■Tuning into stations by frequency

You can tune into AM and FM stations directly by entering the appropriate frequency.

1 On the remote controller, press AM or FM to select “AM” or “FM”, followed by D.TUN.

(Actual display depends on the country.)

2 Within 8 seconds, use the number buttons to enter the frequency of the radio station.

For example, to tune to 87.5 (FM), press 8, 7, 5 or 8,

7, 5, 0.

If you have entered the wrong number, you can retry after 8 seconds.