Connecting the Antennas
This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner.
North American | European and |
models | Australian models |
Connections
Connecting the Power Cord
1 Plug the power cord into an AC wall outlet.
Note
• Before connecting the power cord, connect all of your |
speakers and AV components. |
• Turning on the AV receiver may cause a momentary power surge |
that might interfere with other electrical equipment on the same |
circuit. If this is a problem, plug the AV receiver into a different |
Push. | Insert wire. | Release. |
Assembling the AM loop antenna
AM loop antenna (supplied)
Note
Insert the plug fully | Insert the plug fully |
into the jack. | into the jack. |
Caution
• Be careful not to injure yourself 
when using thumbtacks.
Thumbtacks, etc.
Indoor FM antenna (supplied)
branch circuit. |
•Once your AV receiver is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible reception.
•Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.
Tip
•If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
•If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM antenna.
