Onkyo HT-R758 HTP-691, 5.1ch Home Theater Speaker Package, En-1, Supplied Accessories, Part Names

En

5.1ch Home Theater Speaker Package

HTP-691

Supplied Accessories

Make sure you have the following accessories.

Front speakers (SKF-680)

Powered subwoofer (SKW-791)	Caution
	• The front grilles are not designed to be removed so do not
	attempt to remove them forcibly, as this will damage
	them.
	■ Front

(White) (Red)

Front speakers Speaker cables 11 ft. (3.5 m)

20 rubber stoppers*1

(For Front/Center/

Surround speakers)

Subwoofer	RCA cable 10 ft. (3.0 m)
4 floor pads	SKW-791
Part Names	■ Rear

Status indicator

Off: Subwoofer in standby mode or disconnected from power source

Blue: Subwoofer on

With the Auto Standby function, the SKW-791 automatically turns on when an input signal is detected in standby mode. When there’s no input signal for a while, the SKW-791 automatically enters standby mode.

*1 Configuration of the rubber stoppers may be different from the figure, such as being 2 sheets instead of 1 sheet, but the total number will be same.

Center speaker (SKC-680)

Keyhole slot

Speaker terminals

SKW-791 To AC outlet

OUTPUT LEVEL control

This control is used to adjust the volume of the subwoofer.

LINE INPUT

This RCA input should be connected to the subwoofer pre out on your AV receiver with supplied RCA cable.

(Green)

Center speaker Speaker cable 10 ft. (3.0 m)

Surround speakers (SKR-680)

(Blue) (Gray)

Surround speakers Speaker cables 26 ft. (8.0 m)

	Note
SKF-680/SKR-680	• The Auto Standby function turns the subwoofer on when the
	input signal exceeds a certain level. If the Auto Standby function
Speaker terminals	does not work reliably, try slightly increasing or decreasing the
	subwoofer output level on your receiver.

SKC-680

Keyhole slots

En-1