Onkyo HT-S4100 instruction manual Speakers, Subwoofer SKW-460, Using the Floor Pads

Speakers

Subwoofer (SKW-460)

For detailed information, see the pages in parentheses.

■ Front		A STANDBY/ON indicator
		Red:	Subwoofer in standby mode
		Blue:	Subwoofer on
		With the Auto Standby function, the SKW-460
		automatically turns on when an input signal is
		detected in Standby mode. When there’s no input
		signal for a while, the SKW-460 automatically
		enters Standby mode.
		B OUTPUT LEVEL control (40)
	1	This control is used to adjust the volume of the sub-
		woofer.
		C LINE INPUT (22)
		This RCA input should be connected to the sub-
■ Rear		woofer pre out on the AV receiver with supplied
		RCA cable.
		Note:

2 3

To AC outlet

The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on the AV receiver (page 56).

Using the Floor Pads

If the subwoofer is placed on a hard floor (wood, vinyl, tile, etc.) and playback is very loud, the sub- woofer's feet may damage the floor- ing. To prevent this, place the supplied pads underneath the sub- woofer's feet. The pads also provide a stable base for the subwoofer.

Front, Center & Surround speakers (SKF-360F, SKC-360C, SKM-360S)

■Rear

3

1 Keyhole slots

These keyhole slots can be used to wall-mount the speaker. See page 23 for mounting instructions.

2 Speaker terminals

	These push terminals are for connecting the speaker
	to the TX-SR304 with the supplied speaker cables.
	The supplied speaker cables are color-coded for
	easy identification. Simply connect each cable to the
1	same-colored positive speaker terminal.
	3 Speaker mount/bracket inserts
	These threaded inserts can be used to attach the
2	speaker either horizontally or vertically to a speaker
	mount or bracket.

Note:

Use commercially available 1/4" screws to attach the speaker to a speaker mount or bracket.

11