Recording
STANDBY/ON
| MINIDISC RECORDER | AMCS |
| |
| (PUSH TO ENTER) | |||
STANDBY / ON | CD | REC |
| |
| DUBBING |
| ||
STANDBY |
| DISPLAY EDIT/ NO | YES | |
INPUT | REC MODE | |||
|
| |||
INPUT REC MODE
Analog recording
Recording analog data (data input via the connected audio pin cable)
1 Press the STANDBY/ON button.
The STANDBY indicator goes out.
STANDBY/ON
STANDBY
To check the time remaining for recording
When the MD recorder is stopped, press the DISPLAY button. Each press of the DISPLAY button changes the display as follows:
The number of tracks on MD and the total recorded time → Remaining recording time on MD → Disc name (“No Name” when not set)
To record by erasing all of the existing tracks on a prerecorded MD
Erase all the tracks before you start recording (see page 36).
2 Load a recordable MD.
AMCS
MINIDISC RECORDER
STANDBY / ON | CD | REC |
|
| DUBBING |
| |
STANDBY |
| DISPLAY EDIT/ NO | YES |
|
|
INPUT | REC MODE |
Insert an MD with the label side up, in the direction of the arrow.
Number of recorded | Total recorded time |
tracks on MD |
|
Note
When “Protected” is shown in the display, it indicates that the
3 Press the INPUT button repeatedly until “Analog In” appears.
INPUT
ANALOG IN
Note
•Make sure that the INPUT button and the REC button on the amplifier are set to an appropriate recording source.
4 Select a recording mode.
Refer to Step 4 on page 22 to select a recording mode.
REC MODE
5 Play the recording source.
If a CD player (such as the
24