Connecting Antenna, Connecting the Power Cord | Onkyo PR-SC5508

Connecting Antenna

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.

The AV controller won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner.

(North American	(European and Asian
models)	models)
Insert the plug fully	Insert the plug fully
into the jack.	into the jack.

Thumbtacks, etc.

Indoor FM antenna (supplied)

Note

Caution

•Be careful that you don’t injure yourself when using thumbtacks.

Push. Insert wire. Release.

Assembling the AM loop antenna.

AM loop antenna (supplied)

•Once your AV controller is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible reception.

•Keep the AM loop antenna as far away as possible from your AV controller, TV, speaker cables, and power cords.

Tip

•If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.

•If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM antenna.

Connecting the Power Cord

Note

•Before connecting the power cord, connect all of your speak- ers and AV components.

•Turning on the AV controller may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV controller into a different branch circuit.

•Do not use a power cord other than the one supplied with the AV controller. The supplied power cord is designed exclusively for use with the AV controller and should not be used with any other equipment.

•Never disconnect the power cord from the AV controller while the other end is still plugged into a wall outlet. Doing so may cause an electric shock. Always disconnect the power cord from the wall outlet first, and then the AV controller.

Step 1:

Connect the supplied power cord to the AV controller’s

AC INLET.

To AC wall outlet

Step 2:

Plug the power cord into an AC wall outlet.

En

22

Image 22

Onkyo PR-SC5508 Connecting Antenna, Connecting the Power Cord, North American European and Asian Models, AC Inlet

Contents

Introduction Connections Advanced Operations Controlling iPod & Other Components Board above the apparatus shall be set 10 cm Always consider the environmental issues and follow10 cm 4 at the rear. The rear edge of the shelf or Away from the rear panel or wall, creating a flue-like Precautions Installing the Batteries Supplied AccessoriesUsing the Remote Controller Aiming the Remote Controller Contents Miscellaneous FeaturesProcessing Analog RGB Video Input D-sub 15 for PC V.Color is a trademark of Sony Corporation THX Ultra2 PlusMusic Optimizer is a trademark of Onkyo Corporation Front Panel Pure Audio button Hdmi Thru indicatorFront & Rear Panels ON/STANDBY button Phones jack Zone 2, Zone 3 and OFF buttons Return button Setup MIC jackDisplay AUX Input jacks HDMI, VIDEO, Audio L/R and Digital 19 Input jacks Balance L/R 12V Trigger OUT A/B/C jacks Rear PanelFront L/R, CENTER, Surr L/R Remote Controller Controlling the AV Controller About Home Theater Enjoying Home Theater Speaker Configuration Connecting the AV ControllerConnecting Your Speakers Connecting a Power Amplifier with RCA Inputs Connecting a Power Amplifier with XLR Inputs AV controller Multichannel Connecting the Powered Subwoofers Using Dipole SpeakersBalanced XLR cable Bi-amping the Front Speakers Speaker Impedance Connecting a Balanced Audio Source Stereo audio source with Balanced XLR output AV Cables and Jacks About AV ConnectionsConnected image with AV components Hdmi cable Assignment can be changed 45 to Connecting Your Components with HdmiJack Signal Components Audio return channel ARC function Jack Signal Components Assignable Connecting Your ComponentsFront Rear Auto Power On Connecting Onkyo uComponentsHow to record the video Remote Control North American European and Asian Models Connecting AntennaConnecting the Power Cord AC Inlet Which Connections Should I Use? Monitor Out setting set to Hdmi Main or Hdmi SubMonitor Out setting set to Both, BothMain or BothSub Video Connection Formats Depends on the Audio TV Out setting Monitor Out setting set to AnalogFor details, refer to Video Resolution Chart Audio Connection Formats Turning On Standby indicatorTurning On/Off the AV Controller Turning Off Displaying Source Information Setting the Display BrightnessTOR Using the Home Menu Using the Sleep TimerMuting the AV Controller Starting Components Using Activities Using HeadphonesUsing Activities to Start Easy Macros Changing the Input Display Using Audyssey MultEQ XT32 Audyssey MultEQ XT32 Room Correction and Speaker SetupRestoring Default Turning Off the Components Enter Changing the Speaker Settings Manually Error MessagesUsing a Powered Subwoofer Listening to the Radio Using the TunerTuning into Radio Stations Listening to the Radio Presetting FM/AM Stations Using RDS excluding North American models Listening to Traffic News TP Finding Stations by Type PTYRDS program types PTY Recording Separate AV Sources Connecting a Recording ComponentRecording AV Recording Listening Mode Buttons Using the Listening ModesSelecting Listening Modes Input Source About Listening ModesExplanatory Notes Speaker Layout Listening Modes DTS-HD Master Resolution AudioDescription Input Speaker Source Layout DTS-HD High Audio Listening Mode Description Input Speaker Source Layout Music *5 Modes can be usedNeural Digital Sources such as MP3s and Internet streams Onkyo-Original DSP Listening Modes Common Procedures in Setup Menu Advanced SetupOn-screen Setup Menus Menu Monitor Out Input/Output AssignOUT Main Hdmi Input ResolutionBD/DVD, VCR/DVR, CBL/SAT, GAME, PC, Tape TV/CD, PHONO, Port Component Video Input ` in 1, in 2, Digital Audio Input Analog Audio Input Speaker Setup Speaker Settings Speaker Distance Level Calibration THX Audio Setup Equalizer SettingsBGC Multiplex/Mono Audio AdjustDolby Half Mode Dolby VolumeVolume Leveler PLIIz Height Gain Source Setup Dynamic Volume Reference Level Sync IntelliVolumeName Edit Picture Adjust Random NR*2*3*4*6 Resolution*2*4Mosquito NR*2*3*4*6 Block NR*2*3*4*6 Listening Mode Preset DTS/DTS-ES/DTS-HD 12V Trigger A/B/C Setup Volume SetupOSD Setup Miscellaneous Remote ID Hardware SetupSirius Settings North American models Multi Zone Audio Return Channel Power ControlHdmi ControlRIHD TV Control Lock Setup Using the Audio Settings Speaker Levels Audyssey SettingsDolby Volume Music Optimizer Re-EQ Setting the Incoming Digital Signal Fixed ModeAudio Selector About NET Connecting the AV ControllerNetwork Requirements Listening to vTuner Internet Radio Listening to Internet RadioListening to Other Internet Radio Playing Music Files on a Server Registering Presets*1Station and Song Presets Items on the Internet Radio Top Menu Windows Media Player 11 Setup WAV Supported Audio File FormatsWMA AAC Server Requirements Windows Media Player 12 SetupRemote Playback from Media Server/ Personal Computer About Dlna Network Settings Using Remote Playback Dhcp USB Mass Storage Device Requirements List of the device’s contents appearsAbout USB Playing Music Files on a USB Device Folder1 02SongTrack2 Artist Album 011234 Multi Zone Connecting ZoneConnecting Your Zone 2 Speakers Zone 2 Video Output Zone 2 Maximum Volume, Zone 3 Maximum Volume Setting the Multi ZoneConnecting Your Zone 3 Speakers Zone 2 Out, Zone 3 Out Controlling Zone 2/3 from the AV controller Using Zone 2/3Zone 2 Power On Volume, Zone 3 Power On Volume Zone 2 Component Out Adjusting the Tone and Balance of Zones Controlling Zone 2/3 with the Remote ControllerAdjusting the Volume for Zones Muting Zones Using the 12V Triggers Trigger OUT B and C Using a Multiroom Kit with a Cabinet Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with Other Components Playing Music Files on the iPod/iPhone Standard Mode controlExtended Mode control Top screen list Models sold are different depending on the region Connecting an Onkyo DockOnkyo Dock Cable Using the Onkyo Dock UP-A1 Dock Without the RI Control Controlling Your iPodRI Dock With the RI Control UDock Available buttonsOnkyo Dock Buttons UP-A1 Dock E/rENTER PLAYLISTe/r Looking up for Remote Control Code Preprogrammed Remote Control CodesControlling Other Components Or if you are not sure about the exact model Use q/wto select Search by model numberVia network, and then press Enter Select Skip, and then press Enter Remote Mode BD/DVD Entering Remote Control CodesRemote Control Codes for Onkyo Components Connected via u Tape You can reset the remote controller to its default settings Resetting Remote Mode ButtonsResetting the Remote Controller Controlling Other Components TV VOL q/w Components ButtonsCassettetape deck CH + Disc + Activities Setup Following buttons cannot learn new commands Learning CommandsTo learn more commands, repeat steps 2 Remote MODE, ALL OFF, MY MOVIE, MY TV, MY Music and Mode Making Macros Using Normal MacrosDeleting Learning Commands Running Macros Can’t turn on the AV controller TroubleshootingStandby indicator flashes red There’s no sound, or it’s very quiet About DTS signals There’s no sound with a certain signal formatCan’t select the Pure Audio listening mode Only the center speaker produces sound There’s no picture from a source connected to an Hdmi Remote controller doesn’t workThere’s no picture On-screen menus don’t appear Can’t access the music files on a USB device Can’t learn commands from another remote controllerCan’t access the server or Internet radio Stand-by power consumption Display doesn’t work Sound changes when I connect my headphonesSpeaker distance cannot be set as required How do I change the language of a multiplex source Important Note Regarding Video Playback Nent Video Monitor OUT Video Section SpecificationsAmplifier Section Tuner Section Supported Audio Formats About HdmiAbout Copyright Protection About p-compatible components Using an RIHD-compatible TV, Player, or RecorderOperations that can be performed with p connection Confirm the settings How to connect and setupConfirm the connecting and setting Operate with the remote controller Updating the Firmware via Network Firmware UpdateUpdate procedure Before you start Errors during update via network TroubleshootingUpdating the Firmware via USB Errors during update via USB Video Resolution Chart Output Onkyo Europe Electronics GmbH Onkyo Europe Electronics GmbH UK Branch