Onkyo PR-SC5508 Displaying Source Information, Setting the Display Brightness, Tor

Basic Operations

This manual describes the procedure using the remote controller unless otherwise specified.

Selecting the Language Used for the Onscreen Setup Menus

You can determine the language used for the onscreen setup menus. See “Language” in the “OSD Setup” (➔ 59).

Playing the Connected Component

Displaying Source Information

You can display various information about the current input source as follows. (Components connected to the UNIVERSAL PORT jack are excluded.)

Press RECEIVER followed by DISPLAY repeat- edly to cycle through the available information.

Tip

• Alternatively, you can use the AV controller’s DISPLAY.

The following information can typically be displayed.

■Operating on the AV controller

				Input source
1	Use the input selector buttons to select the input			Listening
	source.			mode*1
2	Start playback on the source component.			Signal format*2
	See also:			Sampling
	• “Controlling Other Components” (➔ 86)
				frequency
	• “Controlling iPod” (➔ 81)			Input signal
	• “Listening to the Radio” (➔ 32)
				resolution
3	To adjust the volume, use the MASTER VOLUME			Output
	control.			resolution
4	Select a listening mode and enjoy!	*1		The input source is displayed with the default name even
				when you have entered a custom name in “Name Edit”
	See also:			(➔ 55).
	• “Using the Listening Modes” (➔ 36)
		*2		If the input signal is analog, no format information is dis-
	• “Audyssey” (➔ 53)
				played. If the input signal is PCM, the sampling frequency is
■ Operating with the remote controller				displayed. If the input signal is digital but not PCM, the signal
				format and the number of channels is displayed. For some dig-
				ital input signals, including multichannel PCM, the signal for-
1	Press RECEIVER followed by INPUT SELEC-			mat, number of channels, and sampling frequency is
				displayed.
	TOR.
				Information is displayed for about three seconds, then the pre-
2	Start playback on the source component.
				viously displayed information reappears.
	See also:
	• “Controlling Other Components” (➔ 86)
			Setting the Display Brightness
	• “Controlling iPod” (➔ 81)
			You can adjust the brightness of the AV controller’s dis-
	• “Listening to the Radio” (➔ 32)
			play.
3	To adjust the volume, use VOL q/w.
				Press RECEIVER followed by DIMMER repeat-
4	Select a listening mode and enjoy!
				edly to select:
	See also:

• “Using the Listening Modes” (➔ 36)

• Normal + MASTER VOLUME indicator lights.

• “Audyssey” (➔ 53)

• Normal + MASTER VOLUME indicator goes off.

• Dim + MASTER VOLUME indicator goes off.

• Dimmer + MASTER VOLUME indicator goes off.

Tip

• (North American models) Alternatively, you can use the AV controller’s DIMMER.

En

26