Onkyo PR-SC5508 Using Zone 2/3, Controlling Zone 2/3 from the AV controller, Zone 2 Component Out

■Zone 2 Power On Volume, Zone 3 Power On Volume

`Last, Min, 1 to 99 or Max (Absolute display)

`Last, –QdB, –81dBto +18dB (Relative display) This setting determines what the volume will be for Zone 2/3 each time the AV controller is turned on.

To use the same volume level as when the AV controller was last turned off, select “Last”.

The “Zone 2 Power On Volume” and “Zone 3 Power On Volume” cannot be set higher than the “Zone 2 Maxi- mum Volume” and “Zone 3 Maximum Volume” setting.

■Zone 2 Component Out

`Use:

Select if a TV in Zone 2 is connected the COMPO-

NENT VIDEO ZONE 2 OUT.

`Not Use:

Select if no TV in Zone 2 is connected the COMPO-

NENT VIDEO ZONE 2 OUT.

If you’ve connected the COMPONENT VIDEO ZONE 2 OUT to a TV in Zone 2, this setting is set to “Use”.

Note

•If the “Zone 2 Component Out” setting is set to “Not Use”, the same video signal as COMPONENT VIDEO MONITOR OUT is output from ZONE 2 OUT (component).

Using Zone 2/3

This section explains how to turn Zone 2/3 on and off, how to select an input source for Zone 2/3, and how to adjust the volume for Zone 2/3.

Controlling Zone 2/3 from the AV controller

ZONE 3 indicator

ZONE 2 indicator

ZONE 3		Input selector buttons
ZONE 2	OFF
1 To turn on Zone 2/3 and select an input source,

press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds.

Zone 2/3 turns on, the ZONE 2/3 indicator lights.

Tip

• The 12V TRIGGER OUT goes high (+12 V).

To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly.

(North American models) You can also select SIR- IUS.

To select the same source as that of the main room, press ZONE 2 or ZONE 3 twice. “Zone2 Selector:

Source” or “Zone3 Selector: Source” appears on

the display.

2 To turn off Zone 2/3, press ZONE 2 or ZONE 3. ZONE 2 or ZONE 3 indicator flashes.

Press OFF.

The zone is turned off, and the ZONE 2 or ZONE 3 indicator goes off.

Note

•When Zone 2/3 is turned off, the output from the 12V TRIG- GER OUT goes low (0 volts).

En

77