Onkyo R-801A instruction manual Connecting the remote control cables

Connecting the remote control cables

If your other components are made by ONKYO and those components are equipped with

connectors, you can control the -connected components with the supplied remote control- ler.

Before connecting

•The unit must be connected in the system hookups for control operations.

•Each component has two connectors. There is no difference between these connectors.

•The components may be connected in any order.

•The hookups on the previous page are necessary independently of the system hookups.

The illustration below is an example of a hookup.

Connections

This unit (R-801A)

MD recorder

Audio

CD recorder

CD player

remote control cable (supplied with every ONKYO component that has connectors except for the amplifier and receiver)

•This is not an example of stacking the components. For the example, refer to page 9.

Note:

Select “CD” as the input display when you connect a CD player to the R-801A’s CD/DVD con- nector, and select “DVD” when you connect a DVD player. If you select the wrong input, the

system will not operate even if the connection is correct.

Toggling between “CD” and “DVD” for the input display

To toggle between “CD” or “DVD” for the input display, make sure that the display indicates “CD” or “DVD,” then press and hold down the CD/DVD but- ton on the remote controller for two seconds or more.

CD/DVD

15