Onkyo R-801A instruction manual Directional Iinkage, Connecting the 300 ohm ribbon wire

Connecting the antenna cable to the 75/300 ohm antenna adapter (Non- European models)

Connecting the 300 ohm ribbon wire:

Loosen the screws and wrap the wire around these screws. Then tighten the screws with a screwdriver.

Outdoor	Indoor
antenna	antenna

300 ohms ribbon wire

Connecting the coaxial cable:

1.With your fingernail or a small screw- driver, press the stoppers outward and remove the cover.

2.Remove the transformer wire A from slit B and insert it into slit C.

3.Prepare the coaxial cable as shown in the diagram.

Connect the 75/300 ohm antenna adapter to the coaxial cable.

1 Insert the end of the cable.

2 Clamp it in place with pliers.

4.Re-install the cover.

					Slit B
					Wire A
Slit C
		✦
✦	✦		✦
✦✦		✦ ✦	✦
	✦ ✦
		6	3	6	1
	mm mm mm
		15mm

2

Directional Iinkage

Directional Iinkage type splitter

To R-801A To TV (or VCR)

Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can inter- fere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.

19