Onkyo S3200 Hardware Setup, Theater-Dimensional Setting, Hardware Remote ID, Tuner

Advanced Setup—Continued

T-D (Theater-Dimensional) Setting

LstnAngl (Listening Angle)

Wide: Select if the listening angle is 40 degrees (default).

Narrow: Select if the listening angle is 20 degrees.

With this setting, you can optimize the Theater- Dimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings.

Front left Front right

speakerspeaker

20°/40°

Hardware Setup

This section explains items on the Hardware menu.

8. Hardware

Remote ID

When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.

Remote ID 1, 2, 3

Note:

If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.

Changing the Remote Controller’s ID

1While holding down the [RECEIVER] button, press and hold down the [SETUP] button until the Remote indicator lights up (about 3 seconds).

2Use the number buttons to enter ID 1, 2, or 3.

The Remote indicator flashes twice.

Tuner

FM/AM (North American/Taiwan models)

See “AM/FM Frequency Step Setup” on page 42.

AM Freq (Asian model)

See “AM/FM Frequency Step Setup” on page 42.

57