Troubleshooting—Continued
•If the AV receiver is installed in a rack or cabinet with
•Make sure you’ve selected the correct remote controller mode (pages 13 and
•Make sure to set the same ID on both the AV receiver and remote controller (page 57).
•Make sure you’ve entered the correct remote control code (page 60).
Can’t control other components
•If it’s an Onkyo component, make sure that the u cable and analog audio cable are connected properly. Connecting only an ucable won’t work (page 34).
•Make sure you’ve selected the correct remote controller mode.
•If you’ve connected an
•The entered remote control code may not be correct. If more than one code is listed, try each one.
•With some AV components, certain buttons may not work as expected, and some may not work at all.
•To control an Onkyo component that’s connected via u, point the remote controller at the AV receiver. Be sure to enter the appropriate remote control code first (page 61).
Recording
Can’t record
•On your recorder, make sure the correct input is selected.
•To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TV/TAPE IN to TV/TAPE OUT or VCR/DVR IN to VCR/DVR OUT).
Others
The sound changes when I connect my headphones
•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono or Direct in which case it stays the same.
How do I change the language of a multiplex source
•On the “7. Audio Adjust” menu, change the “Input (Mux)” setting to “Main” or “Sub” (page 55).
The u functions don’t work
•To use u, you must make an uconnection and an analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally (page 34).
The following settings can be made for the composite video inputs
You must use the buttons on the unit to make these settings.
1.While holding down the input selector button for the input source that you want to set, press the [SETUP] button.
2.Use the Left and Right [e]/[r] buttons to change the setting.
3.Press the [SETUP] button when you’ve finished.
• Video Attenuation
This setting can be made for the DVD/BD, VCR/DVR, CBL/SAT, or AUX input.
If you have a games console connected to the composite video input, and the picture isn’t very clear, you can attenuate the gain.
Video ATT:0: (default).
Video ATT:2: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least 5 seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by this unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.
Before disconnecting the power cord from the wall outlet, set the AV receiver to Standby.
68
