Onkyo S3200 instruction manual First Time Setup, Changing the Input Display

First Time Setup—Continued

2Use the Up and Down [q]/[w] buttons to select “2.Digital Audio”, and then press [ENTER].

3Use the Up and Down [q]/[w] buttons to select an input selector, and then use the Left

and Right [e]/[r] buttons to select:

COAX: Select if the component is connected to DIGITAL IN COAXIAL.

OPT1: Select if the component is connected to DIGITAL IN OPTICAL 1.

OPT2: Select if the component is connected to DIGITAL IN OPTICAL 2.

-- - - -:Select if the component is connected to an analog input.

4Press the [SETUP] button.

Setup closes.

Notes:

•Make sure you also set your digital sources to send out a digital signals. Please refer to the digital sources’ manual.

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Changing the Input Display

If you connect an u-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TV/TAPE IN/OUT jacks, or connect an RI Dock to the CBL/SAT IN or VCR/DVR IN jacks, for uto work properly, you must change this setting.

This setting can only be changed on the AV receiver.

CBL/SAT TV/TAPE

VCR/DVR

1Press the [TV/TAPE], [CBL/SAT] or [VCR/DVR] input selector

button so that “TV/TAPE”, “CBL/SAT” or “VCR/DVR” appears on the display.

or

or

2Press and hold down the

[TV/TAPE], [CBL/SAT] or [VCR/DVR] input selector button (about 3 seconds) to change the setting.

	Repeat this step to select MD, CDR, or
or	DOCK.
	For the TV/TAPE input selector, the
	setting changes in this order:
	TV/TAPE ￿ MD ￿ CDR
or	￿	DOCK	￿

For the CBL/SAT input selector, the setting changes in this order:

CBL/SAT ￿ DOCK

For the VCR/DVR input selector, the setting changes in this order:

VCR/DVR ￿ DOCK

Note:

DOCK can be selected for the TV/TAPE or CBL/SAT or VCR/DVR input selector, but not at the same time.

37