Onkyo S3200 instruction manual Controlling Other Components, Resetting the Remote Controller

Controlling Other Components—Continued

Remote Control Codes for Onkyo Components Connected via u

Onkyo components that are connected via uare controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1Make sure the Onkyo component is connected with an u cable and an analog audio cable (RCA).

See page 34 for details.

2Enter the appropriate remote control code to the REMOTE MODE button.

• [DVD/BD] button

31612: Onkyo DVD player with u

• [CD] button

71327: Onkyo CD player with u

• [TV/TAPE] button

42157: Onkyo cassette recorder with u (default)

• [DOCK] button

81993: Onkyo RI Dock with u(default)

See the previous page for how to enter remote control codes.

3Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that’s not connected via u, use the following remote control codes:

• [DVD/BD] button

30627: Onkyo DVD player without u(default)

32900: Onkyo BD player without u(default)

• [CD] button

71817: Onkyo CD player without u(default)

• [DOCK] button

82990: Onkyo RI Dock without u

Note:

If you connect an u-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TV/TAPE IN/OUT jacks, or connect an RI Dock to the CBL/SAT IN or VCR/DVR IN jacks, for uto work properly, you must set the Input Display accordingly (see page 37).

Resetting the REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default remote control code.

1While holding down the REMOTE

MODE button that you want to reset, press and hold down the [AUDIO] button until the Remote indicator lights up (about 3 seconds).

(3 seconds)

2Within 30 seconds, press the REMOTE MODE button again.

The Remote indicator flashes twice, indicating that the button has been reset.

Each of the REMOTE MODE buttons is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1While holding down the [RECEIVER] button, press and

hold down the [AUDIO] button until the Remote indicator lights up (about 3 seconds).

(3 seconds)

2Within 30 seconds, press the [RECEIVER] button again.

The Remote indicator flashes twice, indicating that the remote controller has been reset.

61