Onkyo HT-R960 Connecting Onkyo Components, Connecting the Power Cord, Auto Power On/Standby

Connecting Your Components—Continued

Connecting Onkyo Components

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the necessary connections (see illustration below).

Step 3: If you connect a MiniDisc recorder, CD recorder, or RI Dock, change the Input Display (see page 48).

With (Remote Interactive), you can use the following special functions:

Auto Power On/Standby

When you start playback on a component connected via , if the AV receiver is on Standby, it will automatically turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components

connected via will also go on Standby.

Direct Change

When playback is started on a component connected via , the AV receiver automatically selects that component as the input source. If your DVD player is connected to the AV receiver’s DVD IN (multichannel input), you’ll need to press the [MULTI CH] button repeatedly and select Multich to hear all of the channels (see page 50), as the Direct

Change function selects only the DVD IN FRONT L/R jacks.

Remote Control

You can use the AV receiver’s remote controller to control your other -capable Onkyo components. You must enter the appropriate remote control code first (see page 93). And remember to point the remote controller at the AV receiver and not the other component.

Notes:

•Use only cables for connections. cables are supplied with Onkyo players (DVD, CD, etc.).

•Some components have two jacks. You can con- nect either one to the AV receiver. The other jack is

for connecting additional -capable components.

•Connect only Onkyo components to jacks. Con- necting other manufacturer’s components may cause a malfunction.

•Some components may not support all functions. Refer to the manuals supplied with your other Onkyo components.

HDMI

IN

ASSIGNABLE

OUT

IN 4

IN 3

(CBL/SAT)

IN 2

(VCR/DVR)

IN 1

(DVD)

DIGITAL IN

COMPONENT VIDEO

L

1

Y

AM

(DVD)

COAXIAL

CBL/SAT

VCR/DVR

DVD

MONITOR

R

CB/ PB

OUT

2

V

V

(CBL/SAT)

ANTENNA

CR/ PR

FMCD

1

S

S

75

(VCR/DVR)

OPTICAL

IN 1(DVD)

OUT

IN 2(CBL/SAT)

IN

OUT

IN

IN

2

ASSIGNABLE

(CD)

IN

OUT

IN

IN

OUT

IN

FRONT

SURR

CENTER

SURR BACK

ASSIGNABLE

FRONT

L

L

L

REMOTE

L

R

R

R

CONTROL

CONTROL

WOOFER

REMOTE

SUB

CD

TAPE

CBL/SAT

VCR/DVR

DVD

R

DVD

e.g., CD player

R L

ANALOG

AUDIO OUT

e.g., DVD player

R L

ANALOG

AUDIO OUT

Connecting the Power Cord

•Before connecting the power cord, connect all of your speakers and AV components.

•Plug the end of the power cord into a suitable wall outlet.

•Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

40