Onkyo SKB-960 To Retry the Automatic Speaker Setup, Changing the Speaker Settings Manually

First Time Setup—Continued

		Auto Speaker Setup
					AUDYSSEY
- - - - - Speaker Detect Error - - - - -
FL	: Yes		FR	: Yes
SL	:	---	SR	: Yes
SBL	:	No	SBR	: Yes
C	: Yes		SW	: ---
Retry
Cancel

The right surround back speaker has been detected but the left surround back speaker hasn’t.

	Auto Speaker Setup
				AUDYSSEY
- - - - - Speaker Detect Error - - - - -
FL	: Error	FR	: Yes
SL	: Yes	SR	: Yes
SBL	: Yes	SBR	: Yes
C	: Yes	SW	: Yes
Retry
Cancel

The speaker type detected does not match what was expected. The speaker may be or incorrect type or broken. Please check that it is the correct speaker type, or that all drivers are working.

Auto Speaker Setup AUDYSSEY

Speaker Detect Error

Retry

Cancel

The number of speakers detected on the second or third measurement was different to the number detected on the first measurement.

Make sure speakers that cannot be detected are con- nected properly.

Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker setup.

❏Write Error

Auto Speaker Setup AUDYSSEY

Writing Error!

Retry

Cancel

This message appears if saving fails.

Try saving again. If this message appears after 2 or 3 attempts, the AV receiver is probably malfunctioning. Contact your Onkyo dealer.

Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker setup.

To Retry the Automatic Speaker Setup

Press the [ENTER] button.

Make sure speakers that cannot be detected are connected properly.

Changing the Speaker Settings Manually

If you want to adjust the speaker settings manually after running the automatic speaker setup, see pages 81–84.

Note:

•Because of the complexities of low-frequency sounds and the way they interact with a room, THX recom- mends setting the subwoofer level and distance manu- ally.

Using a Powered Subwoofer

If you’re using a powered subwoofer and it outputs very low-frequency sound at a low volume level, it may not be detected by the automatic speaker setup. If the sub- woofer (SW) appears on the “SP Detect Result” screen as “No”, increase the subwoofer’s volume to the half- way point, set it to its highest crossover frequency, and then try running the automatic speaker setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level.

45