Using Powered Subwoofers

To find the best position for your subwoofer, while playing a movie or some music with good bass, experiment by placing your subwoofer at various positions within the room, and choose the one that provides the most satisfying results. You can connect the powered subwoofers with SW1 PRE OUT and SW2 PRE OUT respectively.

The level and distance can be set individually for each output. If you’re using only one subwoofer, connect it to SW1 PRE

OUT.

Tip

LINE INPUT

LINE INPUT

Powered subwoofer

• If your subwoofer is unpowered and you’re using an external amplifier, connect the subwoofer pre out jack to an input on the amplifier.

1/3 of wall position

Corner position

Bi-amping the Front Speakers

Important:

When making the bi-amping connections, be sure to remove the jumper bars that link the speakers’ tweeter (high) and woofer (low) terminals.

Bi-amping can be used only with speakers that support bi- amping. Refer to your speaker manual.

Bi-amping provides improved bass and treble performance.

When bi-amping is used, the AV receiver is able to drive up to a 7.2 speaker system in the main room.

Once you’ve completed the bi-amping connections as shown and turned on the AV receiver, you must set the speaker setting to enable bi-amping (page 51).

Note

Speakers A and Speakers B can be wired normally or bi-amped, but cannot be bi-amped at the same time.

Speakers A

Tweeter (high)

Woofer (low)

Front A right

Front A left

Speakers B

Tweeter (high)

Woofer (low)

Front B right

Front B left

En

16

Page 16
Image 16
Onkyo TX-NR5009 instruction manual Using Powered Subwoofers, Bi-amping the Front Speakers, Out, Speakers a, Speakers B