Onkyo TX-NR5009 Controlling Zone 2/3 Components, Zone 2 Video Output, 12V Trigger Out, 8RECEIVER

Zone 2 Video Output

The AV receiver features a composite video output for connection to a TV in Zone 2, so you can enjoy both audio and video in that zone.

Hookup

•Use a composite video cable to connect the AV receiver’s ZONE 2 OUT V jack to a composite video input on your Zone 2 TV.

Main room

TV

AV receiver

Zone 2

TV

Note

•The ZONE 2 OUT V jack outputs video from components con- nected to composite video only.

12V Trigger Out

When Zone 2/3 is turned on, the output from the 12V TRIGGER OUT jack goes high (+12 V and max. 150 mA for Zone 2, +12 V and max. 25 mA for Zone 3). Connecting this jack to a 12-volt trigger input on a component in Zone 2/3 will make that component turn on or off as the AV receiver turns on or off the Zone 2/3.

Controlling Zone 2/3 Components

■Operating on the AV receiver

Input selector buttons

MASTER VOLUME

ZONE 3

ZONE 2 OFF

1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds.

Zone 2/3 turns on, the Z2/3 indicator lights on the display.

Tip

• The corresponding trigger output goes high (+12 V).

To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly.

To select the same source as the main room’s, press ZONE 2 or ZONE 3 twice. “Z2 Selector: Source” or “Zone 3 Selector: Source” appears on the display.

2 To turn off Zone 2/3, press ZONE 2 or ZONE 3. The Z2/3 indicator on the display flash. Press OFF.

The zone is turned off.

Tip

•The corresponding trigger output goes low (0 volts).

■Operating on the remote controller

To control Zone 2/3, you must press the remote controller’s ZONE first.

ZONE turns red while Zone 2 is on, and green while Zone 3 is on.

8RECEIVER

ZONE

Input selector buttons

MUTING

VOLq/w

1 Press ZONE repeatedly, then point the remote controller at the AV receiver and press

8RECEIVER.

Zone 2/3 turns on, the Z2/3 indicator lights on the display.

Tip

• The corresponding trigger output goes high (+12 V).

En

73