Onkyo TX-NR5009 Selecting Speaker Layout, Muting the AV Receiver, Using Headphones

Selecting Speaker Layout

You can set which speakers you want to use by priority.

1 Press RECEIVER followed by SP LAYOUT repeatedly to select:

■9.2 ch playback

Note that these layouts can only be selected when “Front High + Front Wide” is set to “No” (➔ page 51) and all speakers are enabled.

`Speaker Layout:SB/FH:

The sounds from surround back and front high speakers are output by priority.

`Speaker Layout:SB/FW:

The sounds from surround back and front wide speakers are output by priority.

■7.2 ch playback

Note that these layouts can only be selected when “Front High + Front Wide” is set to “No” (➔ page 51) and front high and front wide speakers are enabled (➔ page 52).

`Speaker Layout:FH:

The sound from front high speakers is output by priority.

`Speaker Layout:FW:

The sound from front wide speakers is output by priority.

Note

•This setting cannot be selected when bi-amping the front speakers (➔ page 51) or using Speakers B (➔ page 51) or Powered Zone 2 (➔ page 51).

•Playback conditions may be limited depending on the settings in “Speaker Settings” (➔ page 51) and “Speaker Configuration” (➔ page 52).

•When a listening mode which doesn’t support front high, front wide or surround back speakers is used, this setting cannot be selected.

■Speakers A or Speakers B Configuration

When “Speakers Type(Front B)” setting is set to other than “No”, the relevant speaker indicator lights (A or B), and you can choose a speaker layout between Speakers A and Speakers B. Speakers A or B can be switched regardless of listening modes.

Note

•When using Speakers B, you cannot use front wide speakers.

•While using Speakers B, you cannot use

Audyssey MultEQ® XT32 Room Correction and Speaker Setup, as well as Audyssey Dynamic EQ® and Audyssey Dynamic Volume®.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.

1 Press RECEIVER followed by MUTING.

The output is muted and the MUTING indicator flashes on the display.

Tip

•To unmute, press MUTING again or adjust the volume.

•Muting is automatically cancelled when the AV receiver is set to standby.

Using Headphones

1 Connect a pair of stereo headphones with a standard plug (1/4 inch or 6.3 mm) to the

PHONES jack.

While the headphones plug is inserted in the PHONES jack, =indicator, speaker/channel indicator FL and FR lights. (The Powered Zone 2/3 speakers are not turned off.)

Note

•Always turn down the volume before connecting your headphones.

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio.

•If you connect an iPod or iPhone to the USB port on the AV receiver, no sound will be output from the headphones jack.

En

45