Onkyo TX-NR5009 instruction manual Connection Tips and Video Signal Path, Video Connection Formats

Connection Tips and Video Signal Path

The AV receiver supports several connection formats for compatibility with a wide range of AV equipment. The format you choose will depend on the formats supported by your components. Use the following sections as a guide.

The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

Video Connection Formats

Video components can be connected by using any one of the following video connection formats: composite video, S-Video, PC IN (Analog RGB), component video or HDMI, the latter offering the best picture quality.

The AV receiver can upconvert and downconvert between video formats, depending on the “Monitor Out” setting

(➔ page 48), which generally determines whether video signals are upconverted for the component video output or the HDMI output.

Tip

•For optimal video performance, THX recommends that video signals pass through the system without upconversion (e.g., component video input passing through to component video output).

•To by-pass the upconversion, set the “Picture Mode” setting to “Direct” (➔ page 61).

■“Monitor Out” set to “HDMI Main” or “HDMI Sub”

Video input signals flow through the AV receiver as shown, with composite video, S-Video, PC IN (Analog RGB) and component video sources all being upconverted for the HDMI output. Use these settings if you connect either the

HDMI OUT MAIN or HDMI OUT SUB of the AV receiver to your TV.

The composite video, S-Video and component video outputs pass through their respective input signals as they are.

Video Signal Flow Chart

Blu-ray Disc/DVD player, etc.

Composite	S-Video	PC IN	Component HDMI
		(Analog RGB)

		IN
AV receiver
	MONITOR OUT
Composite	S-Video	Component	HDMI

■“Monitor Out” set to “Both”, “Both(Main)” or “Both(Sub)”

Video input signals flow through the AV receiver as shown, with composite video, S-Video, PC IN (Analog RGB) and component video sources all being upconverted for both HDMI outputs. Use these settings if you connect both the

TV, projector, etc.

Video Signal Flow Chart

Blu-ray Disc/DVD player, etc.

HDMI OUT MAIN and HDMI OUT SUB of the AV

receiver to your TV.

The composite video, S-Video and component video outputs pass through their respective input signals as they are.

`Both: Video signals are output from both HDMI outputs at the resolution supported by both TVs. You cannot select “Resolution” setting.

`Both(Main): Video signals are output from both HDMI outputs but HDMI OUT MAIN takes priority; depending on the resolution, video signals may not be output from

HDMI OUT SUB.

`Both(Sub): Video signals are output from both HDMI outputs but HDMI OUT SUB takes priority; depending on the resolution, video signals may not be output from

Composite S-Video	PC IN Component HDMI
	(Analog RGB)

		IN
AV receiver
	MONITOR OUT
Composite	S-Video	Component	HDMI

TV, projector, etc

	HDMI OUT MAIN.
	Note
En	• The “Monitor Out” setting will be automatically switched to “Analog” (➔ page 48) if not connected to both outputs when “Both”
	is selected or if not connected to a priority output when “Both(Main)” or “Both(Sub)” is selected.

94