Changing the Input Display, First Time Setup—Continued

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Onkyo MiniDisc recorder, CD recorder, or next generation HDD-compat- ible component to the TAPE IN/OUT or VIDEO 3 IN

jacks, for to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

1, 2

iPod photo: If you’re using an iPod photo with the DS-A1 Remote Interactive Dock, connect the DS-A1 to the VIDEO 3 IN jacks.

1	Press the [TAPE] or [VIDEO 3]
	TAPE
	input selector button so that
	“TAPE” or “VIDEO 3” appears on
	the display.
	VIDEO 3

Minimum Speaker Impedance (not North American models)

If you change this setting, you must run the automatic speaker setup again (see page 38).

If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms.

Note:

Before you change this setting, turn down the volume.

1	RECEIVER	Press the [RECEIVER] button,
1	RECEIVER	followed by the [SETUP] button.
		followed by the [SETUP] button.
		The main menu appears onscreen.
SETUP
2		Use the Up and Down [ ]/[ ]
		buttons to select “8. Hardware
		Setup,” and then press [ENTER].
		The Hardware Setup menu appears.
		8.Hardware Setup
		------------------------
		a.SP Impedance :6ohms
		b.PoweredZone2:NotAct
		c.TV Format	:Auto
		d.AM Freq. Step: 9kHz
		e.Remote ID	:1
		f.HDMI Audio Out :Off
		g.SW Input Sensitivity
			: 0dB

2 TAPE

VIDEO 3

Press and hold down the [TAPE] or [VIDEO 3] input selector but- ton (about 3 seconds) to change the setting.

Repeat this step to select MD, CDR, or HDD.

For the TAPE input selector, the setting changes in this order:

TAPE → MD → CDR → HDD

→

For the VIDEO 3 input selector, the set- ting changes in this order:

VIDEO 3 ↔ HDD

3	Use the Up and Down [ ]/[ ]

buttons to select “SP Imped- ance,” and then use the Left and Right []/[ ] buttons to select:

4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.

6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms.

Note:

HDD can be selected for the TAPE input selector or VIDEO 3 input selector, but not both at the same time.

SETUP

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.